I have used the ones you slipon and dip in hot water. They are very simple and fly just like new
Anyone fletch their own carbon arrows? If so, I have a couple questions.
1) What glue do you use
2) What do you use to clean the shaft before glueing
I have a jig, which I forget the name, and use a right hand offset with 4" vanes. I also use gel type CA glue, but have been having problems with the fletchings coming off pretty easy(in my opinion).
Anyone with any help is appreciated.
Thanks,
Tim
I have used the ones you slipon and dip in hot water. They are very simple and fly just like new
ive hunted my whole life, the rest I just wasted
Use fletch-tite glue, I think that bohning makes it. its kinda flexible which prevents a lot of tearing from the shaft yet sturdy enough that they are hard to come off. They cut right off with an arrow stripper as well when it comes time to fletch again. I always use wraps personally, so I just glue directly to the wrap after wiping it down with alcohol. If I'm fletching directly to the shaft, I always us the finest scotch-brite pad you can find and gently scuff the end of the arrow. Be careful though, if you have an arrow with a real glossy finish you can take the finish off with it. But I've NEVER had a fletching come loose, I've cut them which you cant prevent, but they always last me until i decide to change colors or wraps.
A lot of it also depends on the fletch manufactor. You might check and see what they recommend.
Some of them use a ca fast set, type adhesive, and some work better with the fletch-tite adhesives.
Don't ever let the truth get in the way, of a good story
If you use wraps on your shafts you will likely solve your problem with just about any fletching glue. I use Bohning Fletch Tite Platinum and never have a problem with that combination. If you do use wraps, start your first fletch directly over the seam.
Opportunity is missed by most people because it is dressed in overalls and looks like work.
- Thomas Edison
If you are re-fletching your shafts purchase a stripping tool so you wont damage the integrity of the carbon. and carefully remove the vanes. Then with new or re-used shafts i use a very fine sandpaper , dont be aggressive about it its just to rough it up a bit and removes any remaining glue if your re-fletching. Then use a 90% alcohol , which you can get at a drug store , dont over wipe with it , you just want to get any oils , dirt , etc. off the shaft , be sure to let the alcohol dry completely before you start gluing and dont handle the surface after you do this due to the oils on your hand. I have had real good luck with AAE FASTSET , heres a tip after you remove your fletched arrows from the jig put a small drop at both ends of the vanes where they meet the shaft, this will make the vanes stay on much better even with a pass through of your targets etc. Hope this helps ya.
"He is no fool who gives up what he can not keep,
To gain what he can not lose."
Thanks for all the tips...
Tim
I use the quick spin that you dip in water they did loosen up and slide but I re-dipped them in boiling water and they tightened right up.
I use wraps on my carbon arrows to make it easier to re-fletch. Plus it adds a bit of fun to arrow building. My jig is a single stage Bitzenburger and fletch-tite platinum glue. I may switch glues this year though has I've had a few fletches loosen at the front edge while practicing.
Opportunity is missed by most people because it is dressed in overalls and looks like work.
- Thomas Edison
There are currently 1 users browsing this thread. (0 members and 1 guests)